Salesforce

i3311 - Wiper Closed Message

« Go Back

Content

 
Article Number000015042
Titlei3311 - Wiper Closed Message
Body

Issue

 

The printer displays "Wiper Closed - The label wiper arm is closed. Open label wiper arm or tap OK to continue".


 

 

Cause

The yellow wiper arm is flipped over the top of the die cut or precut labels. The wiper arm should not be engaged when using die cut materials. Die Cut vs Continuous Label Materials

 

Die Cut / Precut Materials:

 

 

 

 

Continuous:

 

 

 

Troubleshooting

  1. Move the wiper arm to the up position.

     
     

  2. Install a roll of labels with the continuous label type.

  3. If you are using continuous media, or the wiper arm is not closed using die-cut media, then try power cycling the printer. You can also try engaging and disengaging the wiper arm.

 

Still experiencing the error message? The wiper arm sensor may have failed. Contact Brady Technical Support for your region for further troubleshooting: Global Brady Technical Support Contact Information

URL Namei3311---Wiper-Closed-Message

Powered by